Oatey branded products
Sort by
O036-30234
- Designed for use with PVC pipe and fittings
- Primer pre-softens pipe and fitting surfaces
- Primer pre-softens pipe and fitting surfaces
- Solvent cement bonds pipe and fittings
O036-31346
- O.D. tube cleaning brush cleans the outside of copper piping and plastic tubing quickly and effectively
- Used to clean the exterior of 1 in pipes prior to soldering
- Used to clean the exterior of 1 in pipes prior to soldering
- Cleans copper and plastic piping
- Non-slip outer brush cover
O036-53171
- Rosin flux is contained within the core
- For electrical or electronic work
- For electrical or electronic work
O036-43521
- 3 in or 4 in flange solvent welds inside of 4 in or over 3 in Schedule 40 DWV pipe
- The metal ring provides added strength and cracking-resistance to the flange and can be rotated to allow precise alignment of bolts and screws
- The metal ring provides added strength and cracking-resistance to the flange and can be rotated to allow precise alignment of bolts and screws
- 4 in flange solvent welds over 4 in Schedule 40 DWV pipe
- Without test cap
O036-43524
- Solvent welds inside of 4 in or over 3 in 40 DWV pipe
- Longer length allows for pipes that are cut short
- Longer length allows for pipes that are cut short
- Extra thick flange with four mounting slots
- Countersunk screw holes provide secure attachment to floor. Flange sits flush on floor
O036-43645
- Available in 1/4 in and 1/2 in thickness
- For use when overlaying, replacing or tiling bathroom floors
- For use when overlaying, replacing or tiling bathroom floors
O036-43633
- The strainer snaps onto the drain body
- For use in garage, patio or other outdoor areas
- For use in garage, patio or other outdoor areas
O036-43646
- Can be stacked to desired height
- Builds up an existing closet flange when new flooring is installed
- Builds up an existing closet flange when new flooring is installed
O036-25515
- ProPoxy 20 is a fast-acting, co-extruded, single-stick, epoxy putty that mixes quickly and easily to form a permanent steel-hard bond in 20 mins
- Adheres to almost any surface with strength often greater than the materials it has joined
- Adheres to almost any surface with strength often greater than the materials it has joined
- Kneads quickly and easily
- Seals, mends, bonds and repairs almost anything
O036-30805
- Use on all schedules and all diameters
- Fast-acting cleaner removes surface dirt, grease and grime
- Fast-acting cleaner removes surface dirt, grease and grime
- Flows freely and evaporates quickly
- For use on ABS, PVC and CPVC pipe and fittings
O036-30246
- Convenient handy pack for storing pipe and fittings
- For use in non-pressure pipe systems
- For use in non-pressure pipe systems
O036-00728
- Three countersunk holes and three closet bolt slots for secure attachment to the floor
O036-31403
- Heavier than white tape with density of 1.35 to 1.50 g/cu-cm and thickness of 4 mil
- Heavier than white tape with density of 1.35 to 1.50 g/cu-cm and thickness of 4 mil
O036-42077
- Mechanically attaches over 2 in Schedule 40 DWV pipe
- The drain is fixed to the drain pipe from above the shower base that is ideal for slab construction
- The drain is fixed to the drain pipe from above the shower base that is ideal for slab construction
- Can be used with 1-1/2 in Schedule 40 DWV pipe and 1-1/2 or 2 in copper DWV pipe, when caulking gasket is replaced
- Fiber and rubber gasket provide a tight seal to the base
O036-41594
- Economical, time-tested flexible pan liner
- Liner marked in 6 in increments for ease of measuring
- Liner marked in 6 in increments for ease of measuring
- Dam corners available
- Great cold weather characteristics
O036-42150
- Made of cast brass or plastic
- Ideal for slab construction
- Ideal for slab construction
- Compression gasket tightens around 2 in Schedule 40 DWV pipe with caulking nut and wrench
O036-42261
- Low-profile design allows for installation in tight spaces
- Drain body solvent welds over 2 in or inside 3 in of Schedule 40 DWV pipe
- Drain body solvent welds over 2 in or inside 3 in of Schedule 40 DWV pipe
- Reversible clamping collar is secured with 4 stainless steel bolts into brass inserts
- 2 in IPS threaded strainer barrel is adjustable to allow for easy height adjustment
O036-41630
- Economical, time-tested flexible pan liner
- Liner marked in 6 in increments for ease of measuring
- Liner marked in 6 in increments for ease of measuring
- Without corner dams
- Great cold weather characteristics